 |
|
|
|
High Current Switch
CS-425-HC |
 |
- Direct connection to PC's for general status
monitoring
- Directly control AC loads, such as relays,
lamps or fans, in response to the current
of a monitored AC circuit
- Replaces Differential Pressure switches
- Safety and alarm circuits
- Monitors motors for broken belts or
jammed tooling
- Heater monitoring
|
|
|
The CS-425-HC product is solid-state current switches with N.O. triac outputs to control high-current line-voltage AC loads.
All models have a factory set trip level of approximately 1 Amp and require no field adjustment for easy installation. Internal circuits are
powered by induction from the line being monitored and all models are cULu certified.
|
Operating Temperature: |
0 – 40 ºC (32 – 104 ºF) |
|
Input Range: |
1.25 - 50 Amp-turns |
|
H X W X D: |
49 x 87 x 25 mm (1.95“ x 3.45“ x 1“) |
AC Conductor Hole:
|
19 mm (0.75“) Diameter |
Trip Set-Point (Factory pre-set):
|
Approximately 1 Amp (CS-425) |
Operating Humidity:
|
0-95% RH non-condensing
|
|
Material: |
Self-extinguishing ABS (Cycolac 94V-0)
|
|
Switch Rating: |
120 Vac @ 2.5 Amps Max
|
|
Turn on time: |
< 200mS
|
|
Turn off time (CS-425 only): |
0, 5, 10 or 15 minutes (factory set)
|
|
Mounting Holes: |
2 x 5mm holes spaced 76mm on base
(2 x 0.19" holes spaced 3" on base)
|
|
Output Type: |
Triac
|
|
Leakage
Current: |
< 1 mA
|
|
Manufacturing
Process: |
ISO 9001 Certified
|
| | | |
DRYER BOOSTER FAN OPERATION:
The CS-425-HC can operate a dryer booster fan directly.
These devices sense when a clothes dryer is drawing 1 Amp of current and then closes the output switch
to activate the dryer vent booster fan. When the dryer cycle is complete and the current drops below the
threshold, the output switch will remain closed for a pre-set delay time to allow heat to be removed from
the vent before the switch is opened again. The device output can switch 120 Vac loads up to 2.5 Amps. |
 
        
|